INOCON - Products - Double tube linear units

Simple.Position.Adjustment.

Simple tube-based spindle axis for manual or electrical position adjustment of your application, e.g. for format, height adjustment or width adjustment on production lines.

Our range includes steel and stainless steel variants in tube diameters ø 18, 30, 40, 50 and 60 mm for a wide variety of tasks.

With these adjusting spindles with hand wheel, a trapezoidal threaded spindle with a guide nut is ball-bearing mounted between two guide tubes, and between two end elements a guide element moves on the double-tube system over the stroke range.

This sturdy design is characterized by its high load capacity combined with maximum torsional rigidity and accuracy and is available in the variants with single guide element or double guide element with connecting plate in the three versions:

Right or left hand thread:
The traversing guide element moves to the left or right by actuating the hand wheel
 
Right or left hand thread
Right or left hand thread
Right or left hand thread:
2 guide elements move symmetrically towards or away from each other by actuating the hand wheel
 
Right or left hand thread
Right or left hand thread
Split spindle:
2 guide elements move by actuation of one hand wheel per side completely independent of each other, in this case, an additional support element is used centrally between the guide elements.
 
 
Split spindle
Split spindle
The order code for single tube linear units is structured as follows:
ILD
Linear unit Double tube system
S / E
Steel / Stainless steel
18-60 tube diameter:
ø 18, 30, 40, 50 und 60 mm
1-9 Spindle versions:
1 = right-hand thread, 1 shaft
2 = left-hand thread, 1 shaft
3 = right-hand thread, 2 shafts
4 = left-hand thread, 2 shafts
5 = right and left hand thread, 1 shaft
6 = right and left hand thread, 2 shafts
7 = 1x right and 1x left-hand thread (split), 2 shafts
8 = 2x right-hand thread (split), 2 shafts
9 = 2x left-hand thread (split), 2 shafts
1/2 1 = single guide element / 2 = double guide element with connecting plate
500 tube lengths in mm
300 stroke in mm
V1/V2 V1 = one-sided extended shaft / V2 = double-sided extended shaft

CAD Data of the double tube linear units
Overview CAD Data

General notes of the double tube linear units
Download PDF File

Order code of the double tube linear units
Download PDF File

Load data of the double tube linear units
Download PDF File